L-com Operation of Amplifier LEDs Manual do Utilizador descarregar pdf

IP-00084 Rev. A – 10/06 Page 1/1

L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845

WWW.L-COM.COM E-MAIL: SAL[email protected] PHONE: 1-800-343-1455 FAX: 1-978-689-9484

Operation of Amplifier LEDs

All HyperGain amplifiers have two LEDs visible on the enclosure.

The LED marked TX indicates that the amplifier is transmitting a signal. This LED will

flash during such operation.

The LED marked RX indicates that the amplifier is receiving a signal. This LED will

flash during such operation.

When the amplifier is transmitting and receiving signals at the same time, both LEDs

will flash.

*Note: Some amplifier models have a red TX LED for extra visibility. A flashing red LED

does not indicate a fault.

TX = Transmit LED*

RX = Receive LED

(Amplifier enclosure may vary from example shown)

Sem comentários

L-com Operation of Amplifier LEDs Manual do Utilizador